留ブラPROリテイラー・エディション、改修個所-1
留ブラPROリテイラー・エディション(完成モデル)で行う改修個所を、機会をみながら紹介していこうと思う。
まずひとつめはLEDスイッチのカバーの改修。
これまでのモデルではLEDスイッチ・カバーのエッジが実物同様の直角ではなく、僅かに丸みを帯びていた。
これは量産プレス加工による不可避の産物だった。
また左右・天地のサイズがそれぞれ0.2ミリずつ小さかったことも気になっていた。
このカバーを含むLEDユニットだけはコストを抑えるため中国で量産したが、今回はこのカバーに限り日本で作ることに決めた。
素材も実物と同じ樹脂にする予定である。
徳さんが新たに図面を引き直し、原型も作る。
留ブラPROリテイラー・エディション、改修個所-1_a0077842_16584745.jpg
Tomenosuke Blaster PRO retailer edition
the points of modification -1


I would like to introduce the points of modification of the Tomenosuke Blaster PRO retailer edition at every opportunity.
First of all, I would like to explain the modification of the cover of LED switch.
In the old model, the edge of the cover of LED switch was not square as original, but slightly round. This was an unavoidable result of mass-production press work. Also, I very much worried about the fact that each of the width and height is 0.2mm smaller than original. Only this LED unit including the cover was mass-produced in China for cost reduction, but I decided to manufacture the cover in Japan this time. Material of the cover will be the same plastic as original.
Our crackerjack model maker Nobutaka Toku (aka Toku-san) will remake new drawings and a prototype also.
by tomenosuke_2006 | 2014-01-17 17:20 | 留之助ブラスター
<< DCon 2013 / Jas... Forest Warlord、... >>