レーザーサイトのLEDを光らせるための究極の技-6
The ultimate way to illuminate the laser sight LED by Nobutaka Toku-6

レーザーサイトのLEDを光らせる電源供給の方法についての説明がまだでした。
留ブラ・クロムの場合はマガジンの5灯のLED用の電源ユニットにレーザーサイトのLEDを直結し、ON-OFFスイッチで同時点灯させましたが、今回は異なります。
フロントトリガーをスイッチ代わりにしてLEDを光らせるため、専用のボタン電池を使う単独の配線にしたのです。
試行錯誤の末、徳信尊さんが辿り着いた方法は、マガジンカバーの内側、露出したバレル部にボタン電池のソケットをベロクロで貼るというもの。
ソケットは着脱可で電池の交換も容易です。
というわけで、すべての準備は整いました。
あとは徳さんが製作スケジュールと費用をキッチリ割り出してくれたら、当面は先着20挺でカスタム希望者を募る予定です。
続報をお待ちください。
レーザーサイトのLEDを光らせるための究極の技-6_a0077842_02551776.jpg
レーザーサイトのLEDを光らせるための究極の技-6_a0077842_02552042.jpg
レーザーサイトのLEDを光らせるための究極の技-6_a0077842_16303074.jpg
I haven't explained how to supply power to illuminate the LED of the laser sight.
In the case of the Tomenosuke Blaster Chrome edition, the LED of the laser sight was directly connected to the power supply unit for the 5 LEDs of the magazine and controlled by the ON-OFF switch, but this time it is different. In order to use the front trigger as a switch to illuminate the LED, Nobutaka Toku (aka Toku-san) used a separate wiring that uses a dedicated button battery. After trial and error, Toku-san's method was to attach a button battery socket to the inside of the magazine cover and the exposed barrel with a velcro. The socket is removable and the battery can be easily replaced.
So everything is ready. After that, if Toku-san can figure out the production schedule and cost, we will be looking for people who want custom on a first-come, first-served basis.
Please wait for the next report.
* Unfortunately, this processing service is for only owners of Tomenosuke Blaster in Japan. We do not accept requests from overseas.
by tomenosuke_2006 | 2021-08-14 09:41 | 留之助ブラスター
<< レーザーサイトのLEDを光らせ... 宇宙飛行士8インチ・ダニー、近日入荷 >>